I thought about which printer to buy and came to the conclusion that Voron 2.4 based on FLY-F407ZG with CoreXY rail mechanics and a print area of ​​350x350x350mm is the best option.

Control board with Wi-Fi 500 Kilobits for Voron printers: FLY-F407ZG + Wi-Fi TMC2209 RepRap 32 Bit. AT24C512C-SSHD-T

Kit for Voron 2.4 CoreXY 3D printer.350x350x350mm.

It will cost approximately 50,000 rubles.(Excluding power supply, control board and Raspberry Pi 4)

I will buy everything separately, probably the frame separately, acrylic sheets too, all parts will be about 10,000 rubles each.and clear customs.In 60 thousand, in theory I fit.

I don’t understand why the printer, which is sold as a single Raspberry Pi 4 kit, has it there instead of a screen?

The problem, of course, is that I can’t even imagine what kind of design the 3D printer has, what is where and how it should work, I hope that the assembly instructions exist somewhere.

What do you think about the assembly on such a control board?

Which direct extruder to buy for him, did not figure it out.

Aliexpress offers such a direct extruder option as a novelty in 2021: All-metal active two-tooth extruder.

How good is this direct extruder and how suitable is it, what are the alternatives?

Yes, at least here https://www.t...

Look at https://shui.har...

on the Maestro classic printer...

here is an octahedron and I want to get ...

LTC6811HG-1#3ZZTRPBF Unable to parse option 'second...

Colleagues, I need help with...

New registration data has been sent to your e-mail.

An email has been sent to you with instructions to reset your password.If you haven't received an email within 5 minutes, please check your spam folder and try again.